Manual for “PATHAK” Brand hydraulic hacksaw Machine
Leveling
The leveling
of machine is very important and should be carried our with proper care. The accuracy of spirit level is recommended
as 0.020mm/ Mtr. After proper leveling of machine. The foundation bolts are to
be grouted in larger holes with 1:3 cement
and sand mixture. Sufficient time should be allowed for the concrete to
cure. The foundation bolts are then tightened without undue force.
Electric Connection
If the machine
is supplied in powered version then internal wiring of the electrical motor has
been done in the machine. Electrical
power supply of three phase and proper earthing is required to run the
machine. Please check the machine body
with tester for leak aging of power for safety reasons. Press ON Push button to
the start the power supply.
Electric
Switch Gear & Lead
Our
machines are provided with precision electrical equipments which ensures
dependable operations and long life when handle with reasonable care. Switch
box covers should be kept closed to prevent dust, direct swarf and other
moisture from entering them. Clean switch gears at intervals of three to six
months depending upon the condition of operation. Check carefully seal of lids
and cover with gaskets and sealing compound. Brush off dust and remove seals
with scraper. Do not file or use emery paper cloth on contacts. Contact
surfaces should be clean (Rough condition of contact surfaces does not
contribute to better conduction or service life. Replace contacts when the
contact pressure becomes uneven, too weak or when the spring compression is
less then 0.5mm.
Idle
Running Of The Machine
At the time of
dispatch of machine, the speeds are set for the lowest value. You are requested
to ensure that these positions are maintained at the time of starting of
machine to avoid any accident.
Lubrication
Proper
lubrication of the machine is a matter of vital importance. The retention of
accuracy, satisfactory service and longevity directly depends on its proper lubrication and the
care it receives from the operator. If proper lubrication is neglected it will
result in impairment in accuracy and serviceable life of machine. It is
advisable to lubricate the machine at regular intervals. The best practice is
to fill each oil hole in sequence so that the regular oiling becomes a habit
and no lubrication point is overlooked
Dirt
and work chips should be brushed away before oiling to prevent them to enter
the oil holes.
Regards,
MR. JAGDISH PATHAK , MD
MR. RITESH PATHAK , DIRECTOR SALES
MR. RITESH PATHAK , DIRECTOR SALES
PATHAK MACHINE TOOLS PVT. LTD
“Pyaradham” NH-6 (Bombay Road)
Prosastha Howrah – 711 302
Tel: (033) 2669 0475 , Fax. (033) 2669 1144
E-mail: sales@pathakmachines.com ,
No comments:
Post a Comment