"PATHAK" EXTRA HEAVY DUTY POWER PRESS
Installation
and Foundation
The press
can give satisfactory performance only. If it is on a well dried foundation
made according to the foundation. the loud bearing capacity of the soil should
be taken in to account. Subsequent sagging of the foundation or erosion of the
soil due to moisture will tend to twist the machine. Due regard must be paid to
the dead weight of the press. When deciding upon the thickness and the nature
of floor on which the press will mounted. The press must be labeled on both
ended.
During
shipment machine may have accumulated coating of dust and other contamination's
inspire of providing the protective and wrapping. The machine must be cleaned
before operation.
Precautions & Safety
SAFETY :
All accidents on power presses are
caused by careless operation, neglected repair or lock of inspiration. Even,
through of clutch lock of same time is provided on the press. It is safer to
switch of the power before setting the press tool.
Do not try
to put work on the 'Dies' after the clutch is tripped. Don't try to straighten
a place in the dies after the clutch is tripped. It is Bette to spoil a piece
or die then to loose a finger and hand. Don't finished pieces from the die by
hand. Use a small stock or a soft piece of copper and knock them off. Do not
talk to anyone when you are working. Put your mind and eyes on the work.
WARNING REGARDING PRESS OPERATION :
Keep
presses lubricated. A presses page deals with lubrication system witch is
normally available on presses, but we would warm our patrons that there is no
detail in presses operation more important. then proper lubrication. The
bearing surfaces of power presses necessarily subjected to very high
intermittent load, and failure to keep all the times planate of oil and grease
on the press may readily cause brake down witch will necessitate extensive
delays and costly repairs. The press should be through oiled and greased with
the press in the bearing are will seated.
Careful and
regular inspection is also very essential for economical and safe operation of the
press. The clutch is the vital part of the machine and must be keeping
functioning properly. Broken part witch shows wear should be replaced at once.
The 'Brake' also if not correctly adjusted will cause trouble.
If the
'Brake' is too right, it may heat up and also it will prevent the momentum of
turning shaft from throwing the clutch entirely out, so that it will click.
Wearing the corners of engaging members.
Regards,
MR. JAGDISH PATHAK , MD
MR. RITESH PATHAK , DIRECTOR SALES
MR. RITESH PATHAK , DIRECTOR SALES
PATHAK MACHINE TOOLS PVT. LTD
“Pyaradham” NH-6 (Bombay Road)
Prosastha Howrah – 711 302
Tel: (033) 2669 0475 , Fax. (033) 2669 1144
E-mail: sales@pathakmachines.com ,
No comments:
Post a Comment